pump cover? do i need one?
#1
pump cover? do i need one?
i got an edge juice w/attitude and i was wonderin if i really need a pump cover and how they work or why they are used? also are some better than others or can i buy the cheapest one i can find? one more thing, where can i get an a-pillar that will hold my attitude? thanks!!
#2
The cover is by far the cleanest, longest lasting and most dependable way to tap the pump wire you can get. It's just a plastic type cover that replaces the black cover over the electronics on the VP. It has a screw that goes through it in just the right spot to tap the electronics, this is where you attach your wire from the Juice Module. I got mine from Blue Chip Diesel but there are a few other places that have them also. If you spent all that money on a module, don't cheap out on the last $30 though it is money well spent.
The following users liked this post:
powerfan985 (06-01-2007)
#3
The following users liked this post:
powerfan985 (06-01-2007)
The following users liked this post:
powerfan985 (06-12-2007)
#5
Personally, I think its the only way to pierce the wire. Is it necessary, no, but it is much cleaner and much easier. No unit gets installed in my shop without a Pump cover. Every Juice and PowerMax I send out includes a cover, cause I have seen too many messed up wire taps happen. I think the cover the best thing to happen to the 24v.
The following users liked this post:
powerfan985 (06-12-2007)
Thread
Thread Starter
Forum
Replies
Last Post
HardLuck
Diesel In Distress - Support Ticket
0
06-24-2015 08:04 AM