Advice for building nv4500 for around 600 horse?
#1
Advice for building nv4500 for around 600 horse?
Story is my input shaft snapped, input shaft retainer and unfortunately the bell housing is junk too. While I have the tranny out id like to make it as solid as i can because I only see more horsepower in the future and id like to get some advice on a build. Also what seems to be the best syncros as my 3rd gear is going, might as well hit those up too while im at it. any ideas would be greatly appreciated thanks
#3
@ the OP are you on a stock clutch? If so then a double disk clutch should be part of your build.
Like cummins270 said not much to do ohter than upgrade input shaft.
Dodge Cummins 12 & 24 Valve 5 Speed Performance Clutches
Like cummins270 said not much to do ohter than upgrade input shaft.
Dodge Cummins 12 & 24 Valve 5 Speed Performance Clutches