which injectors
#1
#4
ive never heard of dieselautopower before thanks for the tip ill look them up. the sdx were 450 for the 90hp injetors and on there website they said there .005x10=370's and are egual to 75hp inj. im not sure which factory rating there using i have the 98 with factory of 185hp right now. im looking at the .005x12
#5
#6
sdx most likely claims that 370s equal 5x.010s to help their business. make people think 370s are a smaller injector and that they need sdxs 5x.012s if they want 90 horse injectors. 370s are 5x.012s
this was posted last year by a member here but it's a good chart
Injector Chart
stock 2nd gen inj - vary depending on model but all are 145° injectors
49 state 160 hp - 5x9 .000318
49 state 175 hp 5x9 .000318
180 hp 5x9.5 .000354
160 hp cpl 1863, (actually a 180) 5x9.5 .000354
all calif trucks '96-98 were 180 hp = 5x9.5 .000354
215 hp - 5x10.25 .01025 .000412
300's and 330's same size - 4x12 = .000452
370's - 5x12 = .000565 155° spray pattern
435's - 5x014 = .000769 avail in both 155 and 145° spray pattern
ddp stg III (90 hp) = 50 LPM (liter per minute) 155° 5 hole extrude hone inj <5x12 270 bar
ddp stg IV (140 hp) = 66 lpm - 5 holes smaller than .0135 270 bar
ddp stg 4plus - no longer avail now considered comp waiver must be signed to obtain
ddp comp = 73-90 lpm depending on application same for pop
all four start out as 155° marine nozzles and are extrude honed
this was posted last year by a member here but it's a good chart
Injector Chart
stock 2nd gen inj - vary depending on model but all are 145° injectors
49 state 160 hp - 5x9 .000318
49 state 175 hp 5x9 .000318
180 hp 5x9.5 .000354
160 hp cpl 1863, (actually a 180) 5x9.5 .000354
all calif trucks '96-98 were 180 hp = 5x9.5 .000354
215 hp - 5x10.25 .01025 .000412
300's and 330's same size - 4x12 = .000452
370's - 5x12 = .000565 155° spray pattern
435's - 5x014 = .000769 avail in both 155 and 145° spray pattern
ddp stg III (90 hp) = 50 LPM (liter per minute) 155° 5 hole extrude hone inj <5x12 270 bar
ddp stg IV (140 hp) = 66 lpm - 5 holes smaller than .0135 270 bar
ddp stg 4plus - no longer avail now considered comp waiver must be signed to obtain
ddp comp = 73-90 lpm depending on application same for pop
all four start out as 155° marine nozzles and are extrude honed
Last edited by 93ford; 01-29-2012 at 03:33 PM.
Thread
Thread Starter
Forum
Replies
Last Post
klein444
Chevy/GMC 6.2L and 6.5L
6
03-08-2015 11:42 AM