? why on a 1/4 mile pass its only on the ground for an 1/8th

 

Hmm good point I'll cancel that order asap

 

Gotta watch carryin the front that far. When she comes back down it could cause the rear to unload then we will be puttin the whole front end back together!

 

That header looks awesome! Where did you get it?

 

its factory if your lost in walmart! jk id like one to! im actually thinking about building a custom header and port the exhast side out alot! and matching it to pipes! good thing dave sponsors me hell be sending the money for all the metal and gas and wire for my mig! you do remember that rite dave? ............

 

actualy it hurt my spool up but the top end came alive, got a higher stall converter and will be putting that in once i get the motivation

 

how much would it cost to make another? or where did u buy it? would there be enough room for a s300 over ht4b

 

I bought it from polydyne in Houston tx. It's made by blown away enterprises that the peer of poly dyne has his fingers in. I would get a stainless manifold though and not one of these.

 

i really dont want to spend 450 for a manifold 3 piece or not you know?

 

Then you really really dont want this one