put your thinking caps on guys. on a 94 12 valve i am wanting to take out the two tranny lines that run under neith the bell housing and up to that round tube looking thing on the pass side of the motor. so i would have the two lins coming straight from the tanny straight to the cooler in the front and thats it . would this cause any promblems

 

nope..... mine has the similar thing done only it has 2 trans coolers.....

 

well i want to eliminae them can i

 

put an aftermarket cooler on the front and you should be golden

 

Is that the same as my 90?

 

I put to up in the grill and I barely see above 140 only see 140 when lining up for a trailer but once I get into overdrive or 3rd with the lockout it drops down again fast

 

i use to hit 190 while drag racing but that was the factory cooler..... its going to be very happy after this install...