Quick ? running AFC cover w/2 screws
#1
Quick ? running AFC cover w/2 screws
So i was in the AFC today to check the measurements on my fuel plate before i grind another new one and as i was putting the AFC cover back on i dropped one of the screws and it disapeared into a black hole somewhere and cant be found, do yall think im good to drive on two screws about 14 miles to work tomarrow before grabbing new ones?
Also should i use the X system and put the 2 remaining diagonal from each other or on the same side of the cover?
Also should i use the X system and put the 2 remaining diagonal from each other or on the same side of the cover?
#3
#5
i only have two in mine..... its easier that way..... i havent had any leaks with it.... i use a larger head (10mm) on mine too so that all the bolt heads are the same..... most of the time i run two but i can run three at times.... i dont install the one by the injector lines..... IMO you'll be ok just make sure they are tight
#7
#8