garret exhaust housing specs comapred to regular
#1
01-30-2010, 07:22 AM
garret exhaust housing specs comapred to regular
ok guys, garret turbos measure the exhaust housing by a/r.
how do you convert that to cm? just to get an idea of the size id be comparing one too.
such as a .63a/r
and a 1.06 a/r
how would you get an idea on how to picture than in cms?
thanks. ill pry also post in powerstroke section because they run garrets
how do you convert that to cm? just to get an idea of the size id be comparing one too.
such as a .63a/r
and a 1.06 a/r
how would you get an idea on how to picture than in cms?
thanks. ill pry also post in powerstroke section because they run garrets
#2
01-30-2010, 02:45 PM
6cm2 = 0.41 A/R
7cm2 = 0.49 A/R
8cm2 = 0.57 A/R
9cm2 = 0.65 A/R
10cm2 = 0.73 A/R
11cm2 = 0.81 A/R
12cm2 = 0.89 A/R
14cm2 = 0.97 A R
15cm2 = 1.05 A/R
16cm2 = 1.13 A/R
17cm2 = 1.29 A/R
19cm2 = 1.37 A/R
7cm2 = 0.49 A/R
8cm2 = 0.57 A/R
9cm2 = 0.65 A/R
10cm2 = 0.73 A/R
11cm2 = 0.81 A/R
12cm2 = 0.89 A/R
14cm2 = 0.97 A R
15cm2 = 1.05 A/R
16cm2 = 1.13 A/R
17cm2 = 1.29 A/R
19cm2 = 1.37 A/R
This is a guide that was sent to me to go by from one of my friends who runs turbo WRX's after we had a chat about A/R to CM conversions.This will help a little bit until he sends me the actual formula for the conversion for you which I emailed him about today.......Andy
The following users liked this post:
TwinStackPete379 (01-30-2010)
#3
01-31-2010, 01:43 PM
hammer thanks a ton. it dont have to be extermely accurate.
i just wanted a general idea. thanks alot!!!
---AutoMerged DoublePost---
what makes a ball bearing turbo so much better?
obviously better bearings but is their anything else
i just wanted a general idea. thanks alot!!!
---AutoMerged DoublePost---
what makes a ball bearing turbo so much better?
obviously better bearings but is their anything else
Last edited by dan33klein; 01-31-2010 at 01:43 PM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post
Jet A Fuel
6.7 Liter Dodge Cummins 07.5-12
3
08-03-2015 10:45 AM
