to much blowby
#1
#2
Its normal for an engine to blow oil out the blowby, if you hate the dripping there are kits out there to collect the oil drippings. Its basically a box with a breather filter on the top, and the blowby runs into it. It'd be easy enough to make if you had a welder and a bit of scrap steel layin around.
#4
#6
Not that I know of. If you're using that much oil you have something burned up or a bad ring, or the easiest one to check, a bad Vacuum pump. If the vacuum pump is bad it'll pressurize the block. Do you have a vacuum leak somewhere? Does the heat only blow on defrost?
If its vacuum I'd be surprised, thats an awful lot of oil to go through. You could always compression test the motor and see if its indeed a bad cylinder or ring, but the keystone rings in these things shouldn't go bad.
If its vacuum I'd be surprised, thats an awful lot of oil to go through. You could always compression test the motor and see if its indeed a bad cylinder or ring, but the keystone rings in these things shouldn't go bad.