how to get more hp out of my 95?
#1
#2
you can try your luck with a 4k GSK...
but i suggest getting #60 valvesprings while you're at it...
it isn't as hard as you might think to replace these parts on your truck, a friend of mine did it without removing his head...
but i strongly suggest a new clutch, what are your plans for the truck ?
but i suggest getting #60 valvesprings while you're at it...
it isn't as hard as you might think to replace these parts on your truck, a friend of mine did it without removing his head...
but i strongly suggest a new clutch, what are your plans for the truck ?
#3
#5
600hp (not WHP) is possible with a stock motor and a good set of twins, good injectors and timing... without destroying parts... you might pop your headgasket.... but then you just install studs and a stronger gasket
#7
the HX35 is not really a good "over" turbo, i replaced my HX35 for a HX40 because it would have caused drive pressure problems...
You shouldn't have too much trouble obtaining a HX40, i'm running a HX60 under it, that with 4k GSK, #60 Valvesprings, 5x.018s, SBDD, ARP studs and a thicker gasket... and 22,5° timing... should put you in the safe ~750hp zone... and be streetable...
You shouldn't have too much trouble obtaining a HX40, i'm running a HX60 under it, that with 4k GSK, #60 Valvesprings, 5x.018s, SBDD, ARP studs and a thicker gasket... and 22,5° timing... should put you in the safe ~750hp zone... and be streetable...
The following users liked this post:
Cumminsaddict (10-28-2012)
#8
Chris