wanting a high idle
#1
wanting a high idle
How do I get a higher idle without holding my foot on the pedel? I want to bump up my idle for faster warm ups and for extended idle time in winter or when I have to pull over and sleep. Do they sell a kit or something that I can just flip a switch? Can I make something? Oh and I do have an 03 with an Auto trans. Thanks!
#2
There are 3 ways to do it.
1. buy and install an exhaust break - use the break to put load on the motor to generate heat.
2. Buy a smarty box - the ECM flash will give you that ability without you doing anything.
3. Go to dealer and get flashed. On a 2003 this can prove problematic though and I caution against it.
1. buy and install an exhaust break - use the break to put load on the motor to generate heat.
2. Buy a smarty box - the ECM flash will give you that ability without you doing anything.
3. Go to dealer and get flashed. On a 2003 this can prove problematic though and I caution against it.
#4
Thanks for the replys. I have a Bully dog Triple Dog and have enabled it and I cant get it to work. I also thought that the 03 and 04 didn't have this option, that it was 04.5 and up that had it . I will to the dealership I used to be a service advisor for and use there DRB. Wat are the precautions I need to watch out for?
#5
All good advice if you had a 04.5 or newer but the manual high idle will not work on 03-04. Sorry. An exhaust brake would work for faster warmup times but it will not increase your idle any and once your water temp hits 172 degrees or thereabouts it will disengage anyway. Your truck does have an auto high idle to 1000 RPM once the ambient temp goes below 32 degrees but it is not controllable with the cruise buttons like the 600/610 series motors with doing a flash by the methods talked about above.
#6
#7
I didn't think it was going to work with any of the factory settings or being flashed. Is there any thing like an add on module or kit that has a user set type control? For now I have a nice 2x2 with a foot on one end and a Y on the other end. I place it between the seat and the throttle pedel, adjust the power seat foward and there ya go. Only problem with that it's going to mess up the seat in the long go of things!
#8
---AutoMerged DoublePost---
I didn't think it was going to work with any of the factory settings or being flashed. Is there any thing like an add on module or kit that has a user set type control? For now I have a nice 2x2 with a foot on one end and a Y on the other end. I place it between the seat and the throttle pedel, adjust the power seat foward and there ya go. Only problem with that it's going to mess up the seat in the long go of things!
I know of nothing aftermarket. Sorry.
Last edited by staarma; 10-15-2009 at 01:17 PM. Reason: Automerged Doublepost
#10