EMS Hubs
#2
#4
Not to disappoint you, but there is a thread on TDR about a dis-satisfied buyer. Seems the spindles are redrilled Ford units that do not fit tight into the knuckle (like the unit bearings). The buyer also had lockout-to-hub seating issues...
IIRC, he highly recommended dry fitting everything prior to installation to ensure a proper fit. On another note, they seem to have good customer service...
steved
IIRC, he highly recommended dry fitting everything prior to installation to ensure a proper fit. On another note, they seem to have good customer service...
steved
#5
Not to disappoint you, but there is a thread on TDR about a dis-satisfied buyer. Seems the spindles are redrilled Ford units that do not fit tight into the knuckle (like the unit bearings). The buyer also had lockout-to-hub seating issues...
IIRC, he highly recommended dry fitting everything prior to installation to ensure a proper fit. On another note, they seem to have good customer service...
steved
IIRC, he highly recommended dry fitting everything prior to installation to ensure a proper fit. On another note, they seem to have good customer service...
steved
this is a pretty old thread, did you get them installed??
#7
#9
I started this thread in march when I ordered the hubs . They told me thay would call me when the parts that was needed for my hubs came in, that was in March , still no call . Well , I wound up using the money I had set aside for them for my Southbend 3600 DD anyway. Sence then I've had both hub bearing go bad on my truck.
#10