Valve Lash
#11
#14
#16
Mine were out of spec big time, enough where I could start to here them rattle at 55 mpg, on the intake I could fit the .020 in to it! so it was a good time to do it. It suppose to be done every 150K on schedual a and 135 on schedual b if that means anything to anyone, it took me about 2 hours to get it done, I was in no hurry either... I dont think the owner did it quite right, one because some of the nuts where way to break losse some where S.O.B, but I torqued em down to 24 NM.
Last edited by RanchhandTCR; 02-07-2012 at 06:13 PM.
#18
used the valve cover yea, What you meant the gasket yes I did it was still good and no cracking and it wasnt hard so I reused it. Most valve covers on Diesel are reuable do to the frequent Overhead done. I tell you one thing that every cummins lover hates about a cummins is that last bolt on the valve cover. LOL
#19
last bolt
used the valve cover yea, What you meant the gasket yes I did it was still good and no cracking and it wasnt hard so I reused it. Most valve covers on Diesel are reuable do to the frequent Overhead done. I tell you one thing that every cummins lover hates about a cummins is that last bolt on the valve cover. LOL
Thread
Thread Starter
Forum
Replies
Last Post
Bill in Ballard
Ford 83-94 6.9 and 7.3L General
3
03-13-2016 07:42 PM
Baradium
Ford 83-94 6.9 and 7.3L General
3
03-09-2015 07:15 PM
bonestock
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
02-01-2015 08:41 PM