cummins injector question?
Diesel Fan
Joined: Oct 2010
Posts: 18
Likes: 0
From: southern ohio
i believe the nozzels get torqued to 35 ft/lbs on the body of the injector if thats the question you are asking ..if its the whole injector back into the motor then i'm not sure sorry. hope this helps
If you are referring to the bolts that hold down the injector, they are 10 N·m (89 in. lbs). Those tiny bolts will snap well before 35ft.lbs.
Last edited by RAW; Jan 7, 2012 at 08:53 PM.
I hope your having them pop tested before you install them in your truck.
Thread Starter
|
Diesel Enthusiast
Joined: Jan 2012
Posts: 128
Likes: 2
From: Pueblo West Colorado
right now i have an edge ez tuner and a 150 gph rapter with all 1/2" line. i think with the 150 injectors and the chip set on the lowest setting, it shouldnt smoke that bad from a stand still and still have good power
Thread Starter
|
Diesel Enthusiast
Joined: Jan 2012
Posts: 128
Likes: 2
From: Pueblo West Colorado
no and i was wondering if i need to have them pop tested or can i get away with not doing it. what is the purpose of a pop test anyways?
---AutoMerged DoublePost---
and these are the nozzles i am looking at
eBay - New & used electronics, cars, apparel, collectibles, sporting goods & more at low prices
---AutoMerged DoublePost---
and these are the nozzles i am looking at
eBay - New & used electronics, cars, apparel, collectibles, sporting goods & more at low prices
Last edited by holset cummins; Jan 8, 2012 at 01:17 PM. Reason: Automerged Doublepost
