installed and edge juice with attitude on my truck yesturday and none of the read out on the display show anything. i have power and everything works but no egt, rpm speed or any of that on its display. After install my check engine light came on with low voltage to map sensor and no communication with electronic control module. its a 2000 dodge. any ideas?

 

you could have a bad map sensor you can buy a new one from genos garage

 

think i got the check engine light taken care of. i changed out the adapter i have to use for the edge for the data cable to another one and that took care of that but still nothing on the edge for the gauges showing up

 

If you screen is blank and not lighting up try the signal wire from the juice box itself that was my issue anyway

 

it lights up and i can change the settingsand stuff. its just none of the electronic gauges read anything. they all say 0

 

Did you put in a pyro gauge, ect. If you didnt thats why you dont read andy EGTs

 

ya i hooked the pyro and tranny all up. im thinking there was something more with my data adapter cause i had to try another one(2 of 3 of them were new) cause the low voltage came back again and now everything works. gonna watch it close still make sure its good. and nothings wrong with the programmer cause i sent it back to edge and they checked it out, updated it and new harness.