a/c freeze up
Freeze–up Control A/C Low Pressure Switch Accumulator mounted
Low psi Control Opens < 22-24 psi Resets > 37-43 psi
High psi Control Opens > 450- 490 psi Resets <270 - 330 psi
mounted on discharge line, near compressor
If you have a set of gauges, this may diagnose if a high, or low pressure switch has failed closed. With the gauges attached, if the low side goes below 22-24 PSI and the compressor is still running, the low pressure switch is bad. If the high side goes over 450-490 PSI, the high pressure switch is bad.
It may also be a case of too much freon in the system. When did the symptoms start? Did anything change from when it worked well, and until now?
Low psi Control Opens < 22-24 psi Resets > 37-43 psi
High psi Control Opens > 450- 490 psi Resets <270 - 330 psi
mounted on discharge line, near compressor
If you have a set of gauges, this may diagnose if a high, or low pressure switch has failed closed. With the gauges attached, if the low side goes below 22-24 PSI and the compressor is still running, the low pressure switch is bad. If the high side goes over 450-490 PSI, the high pressure switch is bad.
It may also be a case of too much freon in the system. When did the symptoms start? Did anything change from when it worked well, and until now?
yes it turns off,thats how i thaw it out.takes a few minutes
---AutoMerged DoublePost---
i change the evaporator coil in the dash the blower motor and orfice tube,been freezin up since
---AutoMerged DoublePost---
i change the evaporator coil in the dash the blower motor and orfice tube,been freezin up since
Last edited by txswm58; Jul 17, 2011 at 05:47 PM. Reason: Automerged Doublepost




