Speedo quit after installing BD speed eliminator
#1
Speedo quit after installing BD speed eliminator
I installed a BD speed eliminator Sunday night so I could start doing some boosted launchs. The first time I went to use it I did a 10psi launch and the truck went into limp mode and through the normal codes the RAD throws. So I plugged in my smarty cleared the codes to to go home to see if I did something wrong and the speedo would not register on my dash or in my Edge. Also I have a BD Torqloc that quit working with the speedo. Is there a fuse or relay that runs the speedo? Also I believe that my torqloc is on the same relay (I did not install it). If anyone has any ideas how to fix my problem I am open to suggestions. I will not be able to remove the RAD until this weekend do to my schedule.
#2
I reconnected the wires that were bypased by the speed eliminator and my speedo came back. But the torqloc is not working and my edge is still not receiving speed info. I checked to make sure that the torqlock is getting power. Is there anyone out there that has delt with this or has an idea.
Thread
Thread Starter
Forum
Replies
Last Post
Dertyd
24 Valve 2nd Gen Dodge Cummins 98.5-02
24
06-07-2015 02:45 PM