2 turbos in 2 weeks
Thread Starter
|
Diesel Enthusiast
Joined: Apr 2007
Posts: 210
Likes: 7
From: Wayne County Ohio
ahh ok ok. gotcha. also there is this
took apart the turbo tonight... played a little with the bearings and started putting back together only taking it about 3/4 of the way apart. neither bearing inside the exhaust end came out... when we put the exhaust wheel back on everything fit right and NO PLAY.. put the compressor wheel and housing on.. NO PLAY .... it went from being fairly loose to nothing. all I did was moving the bearings a tad in circular motion and push on the spring in the middle.. dont get that one!!
took apart the turbo tonight... played a little with the bearings and started putting back together only taking it about 3/4 of the way apart. neither bearing inside the exhaust end came out... when we put the exhaust wheel back on everything fit right and NO PLAY.. put the compressor wheel and housing on.. NO PLAY .... it went from being fairly loose to nothing. all I did was moving the bearings a tad in circular motion and push on the spring in the middle.. dont get that one!!
Thread Starter
|
Diesel Enthusiast
Joined: Apr 2007
Posts: 210
Likes: 7
From: Wayne County Ohio
alright. checked the oil pressure and thats what it was. I checked my oil level 2 times and musta just did something boneheaded cuz it was getting low. pressure read around 3 ta 5 ish. anyways. rollin again. thanks guys!
---AutoMerged DoublePost---
psi .....
---AutoMerged DoublePost---
psi .....
Last edited by jaytric9; Aug 11, 2010 at 02:06 PM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post
offroad00
12 Valve 2nd Gen Dodge Cummins 94-98
24
Oct 23, 2014 03:28 PM
