replacing injectors
 

just wondering if i could get some help on how to pull my injectors. is it hard to do? do i need to take it somewhere to get done? im tryin to save some money

check this out and hopefully it will help and answer your questions https://www.dieselbombers.com/12-val...injectors.html

i need the hole instructions all i no is to pull the valve cover and after that im lost

thanks jet thats exctly what i needed that helps so much

If you know the difference in a wrench and a socket you can do it. LOL. It's pretty straightforward.

For my .02, Go ahead and get some new copper washers before you put them back in. Cheap, and worth the trouble.

Just a note, you do NOT have to pull the rocker arms off to get the injectors out...extra step, not necessary, and just takes up more time. I've done injectors on my 24v twice now, and never pulled the rocker arm off...

neither did i (rocker arms). hardest part is getting to the 5th and 6th injector, and thats not all that bad when you get positioned right... be clean and careful. Like they said, really not that diff. those instructions help a ton!

This is a video from Thoroughbred Diesel on changing injectors.

I thought the hardest part to be getting the valve cover off and back on... BTW the chrysler manual doesnt even mention pulling the rocker arms. I found a socket with a washer and a M 8 x 1.25 shankless bolt and nut to make a pretty good puller for those tight injectors.

To pull the valve cover off, all you need to do is push the rubber hose down that's on the passenger side to the rear, and then wiggle the valve cover off. As far as oulling the injectors, just use one of the valve cover bolts, thread it into the top of the injector, and pry up.