Truck will not start
#1
Truck will not start
I have a 2000 Dodge Ram 3500 24 valve 5.9 Cummings. I have replaced the fuel pump in the tank, the lift pump, and I put a new tps on it. It ran good for two days and then shut off like it was running out of fuel. I put a brand new tps thinking the other one was bad and it started up with ether but immediately died. Any ideas would be greatly appreciated!
#2
#4
Those are both lift pumps and you only need one. That could be part of the problem. From the factory your truck came with the lift pump (lp) on the block but they weren't adequate to feed the vp44. Dodge then came out with an "upgraded" lift pump that went in the tank that dealers would put on when the original failed. These are also crap. What I would suggest if you can swing it is remove both of them and put a fass, airdog, or raptor pump on. Since you have the intank lp you will also need a draw straw. In the mean time, take the fuel hose that is running to the block mounted lp off, put it in a bucket and bump the starter to see if the intank lp is working. If it is remove the block mounted lp.
#8