Edge settings for fuel economy when towing light
#1
Edge settings for fuel economy when towing light
Just looking to hear everyone's opinion on the best setting for fuel economy with their edge. I usually run mine on 5 with a low boost setting of 5. I have 285/75/16 studded snows. Empty, mixed driving I get just over 17. Towing with a light two place snowmobile trailer (approx 1600 lbs) on full highway (4 hour drive) I get 13.5 with the cruise set at 65-70. All numbers, hand calculated. When towing, I'm considering trying the #2 setting, which is made for towing (go figure right...) I know one thing, the truck seems to run quieter on that setting too. Drivability seems better too, as opposed to the max setting where the boost and throttle are up and down very heavy when the cruise control is trying to modulate speed. I think I can do better when pulling, 13.5 seems a bit low to me, so I figured I ask you guys.
#2
I find being on anything higher than level 3 makes the truck surge too much while on cruise. It fuels too much for just a little drop in speed, then has to slow down again. IMO, this hurts fuel economy.
I'd try the #2 or #3 setting next time. I rarely take mine above #3 unless I'm playing around.
I'd try the #2 or #3 setting next time. I rarely take mine above #3 unless I'm playing around.
#3
#4
The following users liked this post:
chuffysplace (01-29-2013)
#5
The way I look at it is the ECM/PCM still think the throttle cable still needs to be pulled a certain amount to compensate for the loss in speed. So it pulls that amount, which is probably double of what it needs to pull due to the extra power we add to our trucks. Then it over compensates by releasing too much cable, and it goes back and forth a couple times before leveling out. So every bump in the hiway turns into the engine revving up and down 2 or 3 times.
#6
The way I look at it is the ECM/PCM still think the throttle cable still needs to be pulled a certain amount to compensate for the loss in speed. So it pulls that amount, which is probably double of what it needs to pull due to the extra power we add to our trucks. Then it over compensates by releasing too much cable, and it goes back and forth a couple times before leveling out. So every bump in the hiway turns into the engine revving up and down 2 or 3 times.
Thread
Thread Starter
Forum
Replies
Last Post
1ATony
1A Auto Parts
2
02-03-2016 03:50 PM
1ATony
1A Auto Parts
1
01-05-2016 12:03 PM
1ATony
1A Auto Parts
1
12-07-2015 01:09 PM
1ATony
1A Auto Parts
1
12-02-2015 03:28 PM