Alternate Oil Pressure Sensor Location??
#1
Alternate Oil Pressure Sensor Location??
Installing new Edge Insight Digital Gauge system (gauges only, no juice, no attitude) 0n my 2nd gen 24V.
The OBD for this model year does not pick up oil pressure so I ordered an additional pressure sensor along with their universal accessory set-up.
My question is: Is there an alternate port location I can take oil pressure readings off, without removing and disabling my factory gauge? And where is it located?
Thanx,
SD
#2
#4
#5
RA-
Off Edge Website:
*Click application below to view vehicle specific parameters (PIDs).
**These are parameters for the Insight, Evolution, and Juice with Attitude CS and CTS products.
Dodge 1998.5-1999 24V 5.9L Cummins
Accel Pedal Position, Battery Temp, Battery Voltage, Boost, Calculated Load, Corrected Speed, Engine Coolant Temp, Engine Speed, Fuel Level, Fuel Pressure (Juice w/ Attitude Only), Gear, Intake Air Temp, Throttle Position, Time 0-60, Time 1/4 mile, Trans Temp, Vehicle Speed (Mileage Coach Not Yet Available)
Dave
Off Edge Website:
*Click application below to view vehicle specific parameters (PIDs).
**These are parameters for the Insight, Evolution, and Juice with Attitude CS and CTS products.
Dodge 1998.5-1999 24V 5.9L Cummins
Accel Pedal Position, Battery Temp, Battery Voltage, Boost, Calculated Load, Corrected Speed, Engine Coolant Temp, Engine Speed, Fuel Level, Fuel Pressure (Juice w/ Attitude Only), Gear, Intake Air Temp, Throttle Position, Time 0-60, Time 1/4 mile, Trans Temp, Vehicle Speed (Mileage Coach Not Yet Available)
Dave
Thread
Thread Starter
Forum
Replies
Last Post
Durtyd09
5.9 Liter CR Dodge Cummins 03-07
3
11-11-2015 01:43 PM
powerstroke4178
Ford Powerstroke 03-07 6.0L
4
11-27-2014 02:35 PM