I have a 92d250 and the front sets 2" lower then the rear...what can i do to raise it up? Do any of the spring booster things work? do t hey make a coil spring lift spacer for my truck?

 

they cam like that from factory, just buy a 2 inch leveling kit

 

2" lower?? That a bad thing? I thing it makes it look meaner like that.

 

I have the same problem, doesn't look bad, just wish I had more than 1 or 2" of wheel travel, I am planning on putting some replacement springs when I replace the upper balljoints.

 

Goldies the same

 

Most trucks came like that from the factory. You could do add a leafs but it would make it ride even stiffer. A two inch leveling kit would make it ride the same, and look pretty mean

 

Again they came like that from the factory! its 2 inch higher in the rear cause these are work trucks and your expected to have a heavy load in the back. So when your load is in the back it evens the truck out and doesn't have that sagging look.

 

leave it alone and put some 33s on the back

 

factory, better fuel milage going down hill

 

7226S is the part # for Severe Duty Springs you can have special ordered from any parts store or find online for about $150plus bucks or so, I just put some on mine (92D250) to get the clearance for the 285/70/R17 Nitto Dune's I just put on, no rubbing looks awesome, some have said ride quality suffers but in my opinion it was improved on my truck