ok so excuse the stupid question but is there much if any benefit from installing a hx 35 from a second gen 12v onto a 1st gen 12v

 

I borrowed an hx35w from a friend and it worked good.until i could buy my own, and it was an s300g 57/65/14 and there was almost no difference, I was totaly bummed, it cost 900.00 bucks with no options to up grade. just do you home work before buy.

 

I run a stock HX35 off a 99 and it was a huge upgrade IMO from the H1C

the 35/40 is the way to go IMO for a light mod truck (300-450 hp)

 

bbd 416 how was the install? how did you handle and wastegate?

 

Names Brice by the way good to meet ya

Well being I do this for a living it was not bad

but to change it out you need....

15MM wrench
7/16 deep socket
3/8 drive ratchet for deep socket
flat heat screw driver
and a crescent wrench
and about 15-20 mins

and ya its just a stock HX35 55/70/12W it spools great and keeps cool
I just left the waste gate alone and put on a $15 boost elbow to achieve 35PSI boost thats enough for me

 

sounds too good to be true i know ive seen the elbow you mentioned its a brass 90 of sorts isnt it ? what exactly does it do. thanks for the help

 

exactly I stock the elbows they are a brass 90* elbow with a little allan screw to limit the amount of flow to the wastegate = more boost before the wastegate opens

 

If it's the one I'm thinking of, that was off an 01....dunno if it makes a difference though, just figured I'd let you know!

 

Nope its not seth that one is on being used for mock up for my twin kit
good try tho

 

Lol ok, no prob, just wanted to make sure!