cooooooool air
#1
#3
#5
will do, kind of confusing right now, i have another radiator support im mocking up on before i get it anywhere near the pickup just to make sure...ill snap some pictures in the morning for sure
---AutoMerged DoublePost---
haha i snapped a couple of pictures this morning but my phone likes to be retarded when i want to use it!!! will work on this and try and have them up by evening
---AutoMerged DoublePost---
haha i snapped a couple of pictures this morning but my phone likes to be retarded when i want to use it!!! will work on this and try and have them up by evening
Last edited by Jordan Kopp; 09-11-2012 at 12:20 PM. Reason: Automerged Doublepost
The following users liked this post:
H.R.D (09-10-2012)
#7
i couldnt get it to upload the one i doodled on but you see in the second picture there i had to cut the stock intercooler mounts and the center mount for the lower grill piece off, i need to get a spot weld cutter from my buddys shop this after noon and both of the upright stiffeners are going to have to go for the time being, will snap some more pics morrow depending how far along i get tonight
#9
#10
the pictures may be out of order a bit but it all happened tonight, also there is a pic of the donar truck, 92...nothing special, turned up pump and in the process of putting a getrag 5 speed in.... but i had to cut the radiator support basically to nothing. took the up right supports with the spot weld cutter and then had to cut the bottom horizontal brace to where it was flush with the main piece of sheet metal.