I have a 1995 12v I want to pull the engine and put it in my 1997. The 1997 has a 360(gas). I was wondering how hard it would be, how much it would cost, and what I would all need to do it.
1995 dodge 3500 2wd 5 speed tranny 5.9 12v cummins
1997 dodge 2500 4wd auto 360 5.9

 

You would not have that much expence in it being you already have the trucks maybe a driveshaft other than that it is mostly know how. I just did one recently and it went really smooth you just have to know some about wiring because you have to change the outer harness and the computer and make the harness match up. I also changed the truck from an auto to a manual at the same time.

 

I'd use the Cummins truck axles and springs also

 

Maybe in the rear but by looking at the sig, the 95 is 2wd so SOL on the front end.

 

You may need some new coils then. Usually the gas truck ones aren't as heavy duty due to the weight difference

 

So about how much would this all cost in the end?