Getting ready to build a truck trying to get some HP estimates with these parts

Arp head studs
S300/ht3b turbos.
Sdx 5x.016 injectors.
Airdog 150gph.
Sdx dvs.
4k gsk.
60lb valve springs.
0 fuel plate.
Bhaf.
Pump adjusted
Valve body kit
Torque converter.
Input shaft.
Water Meth stage 3.
3 piece exhaust manifold

 

Well over 38RWHP

 

Depends on what pump,fuel pressure,timing,and mostly tuning. I don't think uncle was generous, you will have at least 5 to 10 more than that.

 

If it were me I would dyno with your present set up and get a baseline, then dyno after and see what you ACTUALLY get out of those mods. If I had to guess I would say 300hp. You biggest issue IMO is going to be getting enough fuel.

 

I don't know, but I'd like to see pics when it is done

 

How would I not get enough fuel

 

I'd think with an airdog 150, upgraded DVs, 5x.016s, a 4k GSK, and modding/tuning your AFC that fuel wouldn't be a problem.......

 

That's what I'm thinking

 

500+

---AutoMerged DoublePost---

dont forget timing

 

Yea timing also i will just have to figure that out after i get it built to see what works out best