Tappet Cover, Foam??
#1
Tappet Cover, Foam??
I was stripping my engine down today, finally took off the last piece, the injection pump, and Im going to paint it tomorrow. I was looking at the tappet cover and there is a foam piece going over it. Its all hard and curled up towards the front. I was thinking about just tossing it and leaving it off. I dont know if its there to keep heat off the fuel pump or sound. Or if its even necessary..
Any ideas or thoughts?
Thanks!
Any ideas or thoughts?
Thanks!
#3
The following users liked this post:
Sudia247 (10-01-2011)
Thread
Thread Starter
Forum
Replies
Last Post
quiksilver1j
1st Generation Dodge Cummins 89-93
1
07-30-2015 12:41 PM
carid
Diesel Bombers Sponsors
0
07-16-2015 05:11 AM