4wd vaccuum
#1
4wd vaccuum
So i have been workin on this vaccuum 4wd i have been fixing all the vaccuum lines on this truc. I have vaccuum down to the switch on the t-case and was not gettin any through it so i replaced the switch with a new one but its still not getting through the switch. I can bypass the switch with a hose and it locks in and out just fine. Is it possable i got a bad switch? Or mabye the hoses are in the wrong place. Does anyone have a diagram where the 4 hoses go?
#4
Here's another good source. Central Axle Disconnect (CAD) System Troubleshooting
#5
Yeah, so do I. Very handy reference. I like the posi-lock kits also. I don't have one personally (2wd), but have installed more than a few!
The following users liked this post:
huntingguy (09-15-2011)
#6
#7
#8
I just bought a dodge for a project truck. I still havent been able to figure it out i am gettin vaccume to the tcase switch and it wont go through it to ether two or four wheel drive i have replaced it twice and still not workin. But if i bypass the switch with a tube it works like it should.i have tried pushing the button for the vaccume switch manually and that doesnt even work. Is it possable i got 2 bad switches?
#9