Well i was going out on a limb and trusted a guy off ebay. The little tag is gone but he said it ws a HX55. And he gave me a bunchof measurments in inches.

We can work with that what were they? Pic of turbo ?

Yeah i got a pic it said holset on it. the measurments he gave me were
Compressore bore 2.52"
Comprssore outlet inlet diameter 2.065"
Turbine Bore 2.890"
Turbine Housing 19 cm
And thanks for any help:jump:

---AutoMerged DoublePost---

oops i mean outlet inner diameter!
Sorry!

Actualy that may not be a terrible single...
64/71 with a .8-.9 housing.

Sounds like somethin cliff would runn lol

ooooo that be good single with a few supporting mods tad nig on exh housing tho

So do you guys think i should throw it on and give it a try? What other mods should i do? And its non wastegated. i dont know if that make it any different.

***** sorry ment big

---AutoMerged DoublePost---

your gonna need a decent sized injector to get it to spool and even at that its gonna have a good bit of lag with that 19cm exh housing. but me being the oddball i am id give it a try

I think i will. Now just need a down pipe and do you know if that is a T3 or a T4. the adaptor is only 20-30 bucks so that aint bad. and i was told 5.012 or 5.014 injectors would either be enough you think?
Thanks Again!

Should be a t4 but I don't know without a pic. With that charger I'd say atleast 5x14's and some decent sized dv's. how is your tranny?