Looking for locker/posi/air locker for a dana 80
#1
#3
I have an arb for a dana 80 35 spline ( thats what most are stock) its for 4.10's and higher gears.
#5
just the locker and bearing's. you will need the compressor, air lines, fittings, and a switch. $400 shipped to your door ( there $850 new and you still have to buy the compressor), I have never ran it was gonna install it on my puller but went with a full spool insted.
#7
#8
The following users liked this post:
94 12valve (01-30-2011)
#10
Thank you, I try and take lost of pic's so you know just what your getting ... I still can't wait to see what your truck is gonna run like with the new gears.
---AutoMerged DoublePost---
just to make sure were on the same page, this locker is for 4.10 and numerically higher gears such as 4.56's and 4.88's. won't work with 3.73's or 3.55's
Last edited by 94 12valve; 01-30-2011 at 02:38 PM. Reason: Automerged Doublepost