New 12v owner
#14
#15
50-60hp? What? Last I looked, a good fuel plate was worth 140hp, plus afc tuning, intake and exahust your probably looking close to 370hp and 700-750 lbs of torque. A gsk would help even more. Not quite near 50-60hp.
But whether or not you believe me on 3mpg or not, I dont really give a ****. I'm just telling you what I have personally seen out of MY trucks with that mod (bhaf or 6637). Note, I didn't say just a filter. I said an intake. The stock design on our 2nd gens is one of the WORST designs implemented. Take it or leave it.
But whether or not you believe me on 3mpg or not, I dont really give a ****. I'm just telling you what I have personally seen out of MY trucks with that mod (bhaf or 6637). Note, I didn't say just a filter. I said an intake. The stock design on our 2nd gens is one of the WORST designs implemented. Take it or leave it.
#17
Got the exhaust pulled off. Truck did have a cat and it was pretty much 100% plugged (260,000 miles). Muffler was about ready to fall off too, really rusty.
Cleaned the truck out too, orginal owner I guess used the glove box as a filing cabinet, even the load paperwork for the truck was in there.
I think I'm going to put a 2" spacer in the front and a small block in the rear. Go up a size or 3 with the tires as well. I can't even get under the truck right now without jacking it up and I'm not a huge guy. Also will help a bit with rpms, 70mph is pretty much all it has.
I got 18mpg out of the first tank I have run through it, not bad at all!
Cleaned the truck out too, orginal owner I guess used the glove box as a filing cabinet, even the load paperwork for the truck was in there.
I think I'm going to put a 2" spacer in the front and a small block in the rear. Go up a size or 3 with the tires as well. I can't even get under the truck right now without jacking it up and I'm not a huge guy. Also will help a bit with rpms, 70mph is pretty much all it has.
I got 18mpg out of the first tank I have run through it, not bad at all!
Last edited by nate379; 03-16-2010 at 12:08 AM.
#18