that one has been tossed around with me a bit I think that would be awesome dont know what it would take to do it but would be pretty cool.

 

I think it would be awesome. Id do it. I saw a You tube video of one in a one ton chevy, it had a 5.9 in front of it. It was bad a**!. Id imagine it would take alot of fab work. They are hheeeaeaaaavvvyyy

 

yea its an o1, i wish the six speed had 2 over drives in it tho, like a really light overdrive and a heavy overdrive, like .85 and .65 cause 1/1 is to low to tow in on the highway and
.73 is a little high to pull in

---AutoMerged DoublePost---

is there anything i should look into the tranny b4 i put it in? do they throw overdrive gear out like the 5 speeds?

 

Drain it, remove the PTO covers and spin the input shaft in each gear.

 

so as long as it spinns over smooth and no bearing slop, and no shavings come out it will be a good transmission

 

Should be!

 

I am new to the Dodge cummins thing. I had powerstrokes and finally got smart. Tell me more about the 10 speed. Where can you get them... also my 06 cummins maby 1 out of 50 starts it turns over like 5 times as much as it would any other time. any ideas

 

Welcome to Diesel Bombers. The 10 speed trans was out of a bg truck. ( Fuller, spicer, exc..) you can retrofit the trans to hug the 5.9. Not sure how yet how to go about it.As for your question, for better respose in the Common rail section for 5.9's.

 

i wonder if you could put in a 2 speed rearend or somthing?
?

 

HOW DIFFICULT IS IT TO CHANGE THE INPUT SHAFT FOR THE T CASE???