Turbo Boost & RPM
#13
You can use ether to locate leaks but they have to be pretty serious to find that way. If you put soapy water on the connections and the load the engine hard any where there is a bubble means that you are loosing boost from there. Another way is to physically take loose all the boots and clamps and check them visually. Don't forget about the oring that seals the turbo compressor outlet to the 90* elbow, they hae a nasty habit of blowing apart if the v-clamp isn't tight enough.
The following users liked this post:
diggerphd (12-09-2009)
Thread
Thread Starter
Forum
Replies
Last Post
Beckalynn211
5.9 Liter CR Dodge Cummins 03-07
4
07-01-2015 12:45 PM
offroad00
12 Valve 2nd Gen Dodge Cummins 94-98
24
10-23-2014 03:28 PM