12 Valve 2nd Gen Dodge Cummins 94-98 Discussion of 12 Valve 5.9 Liter Dodge Cummins Diesels with P7100 Injection Pumps

transmission/transfer case question

Thread Tools
 
Search this Thread
 
  #1  
Old 08-25-2009, 10:40 AM
BAD ASS RAM's Avatar
Diesel Wrench
Thread Starter
Join Date: Mar 2009
Location: clifton,tn
Posts: 592
Received 5 Likes on 5 Posts
Default transmission/transfer case question

i need to know if the transfrer case shares fluid with the tranny and if the transfer case is the same on the auto's and the 4500's.
 
  #2  
Old 08-25-2009, 11:54 AM
GRI's Avatar
GRI
GRI is offline
Diesel Bomber
Join Date: Mar 2007
Location: Mother Nature, New
Posts: 2,958
Received 135 Likes on 111 Posts
Default

no they do not share fluid. but they may use simular fluids. I noticed a lot of transfer cases are using an ATF type oil now.
 
  #3  
Old 08-25-2009, 12:42 PM
BAD ASS RAM's Avatar
Diesel Wrench
Thread Starter
Join Date: Mar 2009
Location: clifton,tn
Posts: 592
Received 5 Likes on 5 Posts
Default

is it the same transfer case for auto and manual?
 
  #4  
Old 08-25-2009, 06:16 PM
kazairl's Avatar
Diesel Bomber
Join Date: Sep 2008
Location: Nebraska Panhandle
Posts: 2,139
Received 126 Likes on 99 Posts
Default

Same transfer case. Only difference is # of splines on the input shaft. The transfer cases uses ATF for fluid and it DOES NOT! share fluid with the transmission.
 
  #5  
Old 08-25-2009, 10:12 PM
tower_ofpower's Avatar
Diesel Bomber
Join Date: Jul 2009
Location: Kingwood, WV
Posts: 1,861
Received 86 Likes on 80 Posts
Default

if it is sharing fluid something is wrong... there's actually a fancy little notch that if the output shaft seal in the transmission is leaking it'll drain the fluid kinda like a weep hole on a water pump to let ya know something isn't right. and to my knowledge they do use the same fluids... they've been using ATF as a lubricant in the x-fer cases for.... 20+ years?
 
  #6  
Old 08-26-2009, 12:50 AM
12valvetater's Avatar
Diesel Bomber
Join Date: Oct 2008
Location: Pennsylvania
Posts: 1,474
Received 35 Likes on 34 Posts
Default

if its an atuo than yes they use the same fluid if its a manual than no they do not use the same fluid
 
  #7  
Old 08-26-2009, 11:35 AM
BAD ASS RAM's Avatar
Diesel Wrench
Thread Starter
Join Date: Mar 2009
Location: clifton,tn
Posts: 592
Received 5 Likes on 5 Posts
Default

so ypu can't interchange them?
 
  #8  
Old 08-26-2009, 01:59 PM
GRI's Avatar
GRI
GRI is offline
Diesel Bomber
Join Date: Mar 2007
Location: Mother Nature, New
Posts: 2,958
Received 135 Likes on 111 Posts
Default

Originally Posted by tower_ofpower
if it is sharing fluid something is wrong... there's actually a fancy little notch that if the output shaft seal in the transmission is leaking it'll drain the fluid kinda like a weep hole on a water pump to let ya know something isn't right. and to my knowledge they do use the same fluids... they've been using ATF as a lubricant in the x-fer cases for.... 20+ years?
I had a few 90's vintage pick ups that I did fluid swaps on still took 90 wt in the transfer cases. those were standard trannys.
 
  #9  
Old 08-26-2009, 02:27 PM
Hammer's Avatar
Diesel Wrench
Join Date: Mar 2007
Location: York,PA
Posts: 714
Received 87 Likes on 64 Posts
Default

To use your transfer case on a stick tranny you will need a different input shaft for the transfer case.

The fluid as stated are different in a stick and transfer case but use the same when its a automatic.They do not share fluids unless you have an issue with the seal in between them and then its a alot of work for a seal which cost less than $10.

I took the automatic transmission fliud out of my transfer case about 150k ago.I run a Schaeffer Oil moly based synthetic gear lube in 20w instead and have had no issues or wear problems at all.While Ma Mopar thinks that tranny fluid is ok it really has minimal lubricating purposes so I removed it........Andy
 
  #10  
Old 08-26-2009, 06:55 PM
tower_ofpower's Avatar
Diesel Bomber
Join Date: Jul 2009
Location: Kingwood, WV
Posts: 1,861
Received 86 Likes on 80 Posts
Default

Originally Posted by GRI
I had a few 90's vintage pick ups that I did fluid swaps on still took 90 wt in the transfer cases. those were standard trannys.
sorry; not too familiar with standards and x-fer set ups... in the auto's atleast 94ish and up sharing fluid is a no no... now that i actually think about the 84 gasser with the NP208 did have abit of fluid in the coupler between the two... my mistake guys.
 


Quick Reply: transmission/transfer case question



All times are GMT -5. The time now is 12:18 PM.