1997 12 valve broke the sensor above crank shaft
#1
1997 12 valve broke the sensor above crank shaft
Hello, i just fixed the killer dowel pin on my 1997 12 valve, as i was putting the harmonic balancer on i did not notice the sensor above was improperly located and it broke :-( is this a Crank postion sensor? and where do i get one? How do i instal it correctly? is there a measurment or gap between the balancer and the sensor? also what does this thing do???? i am new to diesels and electronics. P.S looked for this part all over and it seems like no one talks about it or sells it online, or maybe i just don't know how to type it in the search engine? Thanks for any help!!!!!
The following users liked this post:
392hemix (02-24-2009)
#5
Thanks, i guess i know what i am buying from auto zone. Do you know how that is ajusted? or does it just bolt up? i would imagine that you would use a feeler gauge to adjust? P.S Thank you for your fast reply, i am very new to this and am enjoying the site
---AutoMerged DoublePost---
well, i guess i will never make that mistake again 108.00 bucks, that not cheap, can i drive the truck without that? i didnt even want to try or even start it untill i knew what that sensor did? you said it just controls the tac?
---AutoMerged DoublePost---
well, i guess i will never make that mistake again 108.00 bucks, that not cheap, can i drive the truck without that? i didnt even want to try or even start it untill i knew what that sensor did? you said it just controls the tac?
Last edited by 392hemix; 02-24-2009 at 10:11 PM. Reason: Automerged Doublepost
#7
#8