pick of my dually to single wheel flatbed.

 

pick of truck before i did the flatbed conversion

 

Where did you get the FB ? That thing sure looks sexy with that on there .. my truck is just like that only 2 wd ... what was the cost ? PM me with info please

 

heres another pic. it cost me about 500 bucks in material to make the flatbed. it was easy to make but it was over 100 degrees the week i was building it that made it seem hard!

 

i used 2by5 inch square tubing to make the outside rectangle then used 2by4 inch square tube to do the 4 inside rails so when i used the sheetmetal to lay on top of the bed it sat inside about 3/4 below. i went 76 inches outside to outside and 8 feet front to back to fit the single wheel.i used 2 inch square tube to run front and back to lay on the trucks frame rails. that set the bed at a nice level.then ran 8 four inch channel off the 2 inch rails that run along top of the truck frame at about 5inches long each to connect to the frame holes. the front section i used 2 inch square with sheetmetal leftover from the floor of the flatbed that i had cut from a 10 foot by 71 inch piece. i had the shop cut 2 feet out of the 10 foot sheet so i could use 8 feet for the top and 2 foot for the front rail.now i have bedliner on the inside of the floor of the bed which looks great!

 

NICE ... I will be using these measurments to do something like this I think ...

We shall see ...

 

What did you do with the front wheel adapters? if you want to sell them let me know.

 

darn i gave them away already. sorry.

 

let me know if you need more info.

 

Oh I will .. U can count on it !!!