Does anyone have a 47RE bolted to a NP 241 HD sitting out of their truck so they can take an exact measurment?

I bought a ZF 6S-750 6 speed manual out of a 6.0 Powerstroke along with a NP 271 I am going to be dropping in my QCLB 12v. I am hoping to get all the measurements, so I can get a driveshaft built to make the swap a 1-day job.

This would help me out a lot since it's hard to get exact measuremnts with everything still in the truck.

Thanks!

 

Maybe it would help if I was more specific on what I am looking for..

I am looking for the measurements (length) of the 47RE and the NP271HD.



Once I get that exact measurement, I can add that to the drive shaft measurement, and subtract the length of the transmission and t-case I am going to be putting in, and the number left will be the length of my new drive shaft.

 

I will measure my 47re but its 2wd ..... maybe minus the small tail shaft ? ... will take mulit point measurments and post tommrow on lunch .... as for the T case I'm no help..

 

I am not sure the differences in length from the 2wd to 4wd 47RE's, but I want to be as exact as possible.

Thanks though!