Yesterday I put 5k springs in my 12 valve.. I fired it up and it idles at 2600 Rpm's I took all the Shims and the smallest springs out and couldn't see anywhere that the throttle was hung up.... Any tips would be appreciated...

 

cds springs?
i believe you only do 1 or 2 clicks on them, might have to idle the truck down.

 

Which springs r u cAlling the CDs springs?

---AutoMerged DoublePost---

The only springs in it right now are the biggest spring and the 5k springs when I took it apart there was the big spring then the stock spring then a small spring and some shims

 

5k's SUCKKKKKKKKKKKKKKKKKKKKKKK!!!! to get set up for the street! best of wishes. they are very very touchy. chances are once you get the idle down the truck will die when you put it in gear or swing 500 rpms going into gear.

 

Why 5k GSK ? Are you trying to spool a HX82... sure hope you have 120# Valvesprings to go with that..

 

Can you back off any clicks? I was reading about tightening my stock springs a few clicks to raise the gov., and read that the idle will raise.

 

backing off a 5k??? not really they are freakin stiff, very tricky little buggers.