installed my ppe standard today. it takes a lil time to do it but wow it is worth it. im glad i listened to everyone. ditched the banks system and installed the ppe programer. what a difference of night and day. my only thing is i just dont know what the best seting would be to run yet and i have a bad feeling that this programmer is goin to get me into some trouble, there just such a power difference. i just cant get over it. thanks everyone for the advise as to what i should get. and it was bought from one of the dealers here on db...

 

Told you "you would like". Enjoy more power but be careful with high settings. Also make sure the defuel between shifts is on that will help save the tranny.

 

when i put the tune in i set it on 3 and where it says defueling is it was marked yes... she still didnt poor allot of smoke which might be a good thing, plenty of power though. but smoke looks so cool though...

 

I loved the smoke from lvl 5 on the stock truck but once i did the exhaust and intake i cleaned up alot. Just from experience dont use lvl 5 and have it pull hard in OD. I got to about 6 pounds of boost and the convertor let go. I run around at lvl 2 it still jerks shifting into OD. If you know your going to be hard on it turn OD off.

 

well i have full exhaust and intake on the truck and i dought i run lvl 5 until i upgrade "cant afford the trans to come apart right now" or right before i upgrade the trans, but i am going to test lvl 4 out tonight. most likely im goin to leave it at lvl 3 after i play with it some tonight.

 

Let me know how it goes?

 

ill let ya know something later tonite or sometime tommorrow. i just gota remember to turn od off. im guessing trailer mode will work.

 

It will work just make sure you run the tranny through the relearn cycle every time you change power levels. Get out there and have some fun with it.

 

well i ran it on lvl 4 last nite. all i have to say is holy **** what a power difference ... i turned it back down and after running it on lvl 4 lvl 2 aint nothing. i think im goin to leave it on lvl 3. im goni to go and set all my calibrations today and leave it alone after that and do a tranny relearn..

 

doese it monitor injector balance