oil rail plug thread size?
#1
#4
#6
could i take the factory plug out and drill and tap in a 1/8npt to 6 an fitting? do a 1/4" hp hose crossover that way? basically making the fitting yourself?
I have 5000psi hose i could use... or could do it out of 1/4" id stainless tubing. Use a copper piece to mock up the bends to the adapters.
I have 5000psi hose i could use... or could do it out of 1/4" id stainless tubing. Use a copper piece to mock up the bends to the adapters.
#7
#8
#9
#10
Your scaring me with that one. In a dive hose 1/2" denotes the size of the hose, not the thread of the fitting. The fact that its lucky enough to be a 5ORB thread doesn't mean its a good idea to do what you did. The 5K gauge used in dive consoles is for gases, not liquids, the internals of the gauge are not designed to be in contact with liquids nor the hose in contact with petroleum oils. Next you'll say you had an old Datatrans, 750GT or an Aladin X and stuck the remote transmitter in the oil port so you could wear around your HPOP gauge. This was one idea you should of kept to yourself.