2000 6.5 wiring help needed. Dt360 swap
#12
Thanks for the reply. Only wires hooked up at the moment are tack wires and tach acc wire. White wire to tack signal post on the 22si alt and the brown wire to acc on.
#14
it is connected correctly and has power. This alt charges when it is in motion, doesn't require a signal at all. I hooked it up anyway
#16
Well I could certainly go back to the factory alt, however the 22si has a tach signal post, I just need to match the pulley Size to get an accurate reading. I have two spare ECM units I'll probably see if perhaps a blip of current while shambling wires around didn't fry the ECM. Otherwise I'll just get auto meter guages for everything :-(
Thread
Thread Starter
Forum
Replies
Last Post
mcclusk
24 Valve 2nd Gen Dodge Cummins 98.5-02
3
02-21-2015 09:50 PM