dont do the stainless. Rusts underneath and you cant get it off. I have them on my 01 and hate them. Same goes for the trim pieces that fit on top of the wheel wells.


Id do linex if possible.

Dad found out the same thing with the wheel trim, they are just catch all pieces of junk. As for the stainless yes I have seen it go both ways... But the set I have has the complete back of them covered in 3m stick'um so im not worried about crap and moisture getting behind them as well this truck will not be driven in winter and not very much in the rain...

More progress... Stainless rocker trim was some beautiful stuff that fit awesome! Made the install go trouble free. Just prepped the rockers with wax and grease remover and a healthy dose of rubbin alcohol. Turned out great!

Attachment 46137

Attachment 46138

Attachment 46139

Attachment 46140

Attachment 46141

Attachment 46142

Attachment 46143

Also got my new hitch, worth every penny IMO!

Attachment 46132

Attachment 46133

Also started on my sled stops today as well. I used 2x2x1/4" square tube and 2x1/4" flat stock foe the end caps

Attachment 46134

Attachment 46135

Attachment 46136

Looks freaking sweet!

Nice progress! Looks like it is coming along nicely! I just can't wait to drive mine again! Its getting so close I can taste ittttttt... I just have to start her up sometimes to hear her purrrr.

in that pic of you hitch installed ... is that the height your gonna pull with it set at?

---AutoMerged DoublePost---

looks to me like you should turn it upsidedown

Ha nooooo, I had it that high so I could measure off of the back of the box to the front of it so I could get a good idea on how far to get the sled stops out :D The hitch was 32" in that pic! The clevis part can be run either way btw for a total of 18 different heights :pca1:

:tu: cool, I was really hoping you were not gonna hook with it like that:c:

bet u wish u wouldve made that stack a little taller.. i hated my short stack, it looked cool but wat a mess :argh: