Lots of LOVELY Codes that I need help on
2003 F250 XLT FX4. 166,000 miles. Batteries were replaced about 6 months ago, ICP sensor about 1 month ago, IPR Valve about 1 1/2 years ago, FICM about a year and a half ago.
Now I found 5 hidden codes for my truck and am a lost cause on these. First of all, I oddly have to spray it with ether (very unfortunantly) to start it whether its HOT or COLD. Otherwise she won't start. But the codes are U036-Software Incompatible with FICM P2617-Crankshaft Output Signal Open P2291-Injector Control Pressure Low when Cranking P2290-Injector Pressure to Low P0603-Control Module Keep Alive Memory Malfunction Wondering if anyone has had these problems. When it does run, I DO NOT have any power loss, it likes to stall out on me (has trouble holding idle), and again, I SADLY and UNFORTUNATELY have to spray it with ether to fire it up. Any help would BE GREAT. ---AutoMerged DoublePost--- Only thing Aftermarket on the truck is exhaust. 4" down, 5" straight and 6" tip |
Do you have access to code reader or scanner? If those codes were hidden you may have memory codes from past problems. I would get current ficm volts, cranking and running, oil pressures and fuel pressure. Was replacement ficm flashed to match truck? I'm wondering if you have a harness issue or chafed wire on crank sensor. Do you have overdrive light flashing?
|
Kinda had the same problems started getting all sorts of codes And it turned out to be the FICM going bad. Low Voltage is a bad thing. So 1st make sure that your alternator is good when running 13.6 - 14 volts . Then check the FICM Again.
|
All times are GMT -5. The time now is 12:55 AM. |
© 2024 MH Sub I, LLC dba Internet Brands