No problem.

Here is my second attempt at Fummins motor mounts:

http://i229.photobucket.com/albums/e...Picture048.jpg

I used all 3/8" plate, and some big super stiff bushings I found at Ballistic Fabrication. I welded some ears to the crossmember to bolt up to. So, far they've worked pretty slick...hardly any engine twist at all due to torque. Not the greatest design, but it works. :w2:

what do you torque the mounting bolts to - just curious:s:

anyone ?

92 cummins f250, those mounts look perfect for the setup I'm going to have in my 75 f250. What size angle iron is that? I'm hopefully going to be using 3 inch by 3/8 flat bar and I ordered 4x4x3/8 angle but your angle looks much larger. Hopefully I will not have any problems with bending due to my stuff being 1/8 thinner. Mounts look good and I'm glad that iyou can just go to any auto parts store and get a motor mount for a 92 dodge diesel.

If I were u guys I would of used ford 460 big block mounts they are much bigger then the 1st gen dodge ones and are almost the same but the 460 ones are 3 times as wide but I do like urs 93_fummins