v2203 in 88 s10
 

this is my first post i joined so i could see what all you guys are doing

---AutoMerged DoublePost---

once i figure out how to post pictures i wil put some up of my adapter and modified flywheel and pullys

Welcome, looking forward to seeing your build!

how to post pics from the phone
 

i need help on how to post pictures from my phone i click on attach nothing happens i can not open it

Pictures
 

Here are some pictures of the progress I've made so far....

Keep up the good work.

Nice work! I never thought of welding the plate to the cast bell, but I didn't have that much cast thickness left for my spacing. You seem to have double the spacing I have. I like your belt setup, but the tensioner may not do too good on the torque side of the drive pulley.

FTE you made me go back and look. But once I did FTE is correct about the tensioner on the Torque side and also I am not sure if the Water Pump pulley has enough contact with the belt for proper operation under load of the water pump.

im going to try out the water pump before i put another pully on it as far as the tensioner go's there is not alot to work with on the other side for a mounting location and from everything i can tell the bellhousing is cast steel so welding was not a problem but thanks for all of the info thats why i joined

The tensioner will work in that location locked in place, not spring loaded.

i had it running today and the tensioner alittle at idle but smooths out after that