Diesel Bombers

Diesel Bombers (https://www.dieselbombers.com/)
-   Chevy/GMC Duramax 07.5 -10 LMM (https://www.dieselbombers.com/chevy-gmc-duramax-07-5-10-lmm/)
-   -   Questions on Batterys going dead, I-Arm, Tranny cooling lines (https://www.dieselbombers.com/chevy-gmc-duramax-07-5-10-lmm/64797-questions-batterys-going-dead-i-arm-tranny-cooling-lines.html)

Dirtymax13 12-13-2010 09:31 PM

Questions on Batterys going dead, I-Arm, Tranny cooling lines
 
First problem is batterys, If my truck sits for any lenth of time it either starts hard or is dead if i run my radio without running 20 mins max dead alternator good batterys test good, Second I-Arm for steering rattels when turning i have seen other post about this where would i buy a new aftermaket one ,cause i heard factory will do the same thing again, Third my tranny cooling lines have been replaced once already and a diferent one is leaking now 50,000 wtf

BriteWhiteRam 12-14-2010 01:37 PM

cooler lines are garbage, get some new ones made up or buy a kit like i did
chevy silverado duramax transmission cooler hoses on eBay.ca (item 180599590768 end time 21-Dec-10 10:59:12 EST)

2500HeavyDuty 12-14-2010 02:37 PM

your going to have to pull the amp meter out and test for any unwanted battery drain with the truck off.

do you have any aftermarket electronics installed?

BLACKDX 12-22-2010 02:20 PM

Just do what BWR said or take your lines of and go to a hose shop on get some real ends and hose made up.. They will never stop leaking especially if your in a colder climate..As for the Batt ya must have a drain on it some where, I know mine won't handle much as well but its only sometimes. I think if something is left on plugged in it must activate the BCM or something cuz mine has did this as well..the only thing i had plugged in was a phone plug. I know with my PPE sometimes I could never load a tune it would lock up, had to unplug several times and reastart the truck ans so on. Was told by PPE that if the BCM stays powered up that that would cause issues with the programming.. Dunno

Dirtymax13 12-22-2010 10:41 PM

Thanks for your help


All times are GMT -5. The time now is 11:12 PM.


© 2024 MH Sub I, LLC dba Internet Brands