My oil pressure gauge and light currently do not work and havn't since purchase, I want to sort this out as it makes me paranoid knowing i wont get any warning if pressure suddeny drops. I've had a bit of a look around the motor and can't locate the oil pressure switch/sender unit could someone please tell me where it is so i can test it and the gauge

 

i have a 98 an it was on the driver side about mid way of the motor its kinda tricky to get to but i could see it through the fender wall between the shock tower an inner fender. i personally went through about 4 sensors before i got ont to work. i also put a mechanical gauge on for peace of mind

 

it right under the back of the IP on the side of the block

 

Interesting, I have a spare plug hanging around that area, but also some connected, it seemsot have no spare counterpart hanging about...Strange, will investigate further soon.

 

Is it just a small plug in the block? The thing i've been looking at so far is part of the lift pump I think .

 

its close to it but i little further towards the front of the motor

 

Just hope your senser is not bad, mine is and dodge wants 386$

 

The oil pressure sensor is like $20 at autozone. Bought mine last month there. It's a PITA to change but doable.

 

Can someone take a picture? As i'm having real trouble finding it, Huge motor but still hard to get at!

 

autozone and napa are good places to buy one but i went threw three of them before i got one to work