HEY YAWL...
I HAVE BANKS ON MY TRUCK RIGHT NOW AND IVE HAD TO SEND IT BACK TWICE TO GET REFLASHED AND IT JUST DONT SEEM LIKE IT IS WORKING AGAIN... IVE BEEN LOOKING AT THE PPE STANDERD. I WAS WONDERING CAN THAT BE RAN WITH THE BANKS? OR JUST TAKE IT OFF? ANOTHER THING I WAS WONDERING IS IF I WAS TO GET IT WHAT WOULD BE THE BEST SETING TO RUN IT ON. THE TRUCK HAD FULL 4IN EXHAUST NO CAT OR MUFFLER, AND INTAKE ON IT. HOPE YAWL CAN HALP ME OUT..
THANKS
CRAIG.

 

I would ditch the banks and go with PPE. Anything over 90HP you run the risk of damaging the tranny. The tranny wont hold much more than that. Also the injection pump is about maxed out at 90 over.

 

I have the PPE economy and I run it at 80 120 limped my tranny so far so good!

 

thanks, im just trying to figure out which one to get at this point.

 

I have the ppe hot just the one with 6 settings up to 300hp. and i put in a stage 2 transco shift kit and run the programmer on level 4 its got plenty of go but is daily driver friendly.