:Caution:
Got three bad front rotors from Napa last week, they were from China. The castings were seriously shifted off center. After I installed them the ABS sensor wheel would make a slight scraping noise and the whole housing you could see the "run-out" near a 1/4 to 3/8 inch.
this was on a 1999 3500 Dodge 2wd.

 

When buying rotors make sure they are made in America. The parts makers from overseas dont have the smelting experience to make a quality product. Pay the little bit extra and get American made.


I HATE Chinese junk !!

 

Good luck with that. From what I have heard unless you are getting EGR, Baer or the like all the others are cast in China and most are machined there. Some of them come here for machining.

 

That sucks...I know I sure cant afford Baer.

 

I spent a butt load a money on my EGR braking system, braided stainless lines, rotors and calipers and I will say that the lines and calipers have been great but the rotors have warped just as fast as the Auto Zone or Napa blue light specials did.

 

to be honest, i got some baer "decela rotors" for my durango.. love them alot. were about 250.. IIRC. (but thats b/c i also bought some pads too). dont tow at all with them, so i cant say. but i know they are drilled/slotted. not the most surface area, but will stay cool. if towing, i reccomennd slotted...