Does anybody have any experience with cut-resistant gloves?

Boats like to cut me. I have a ton of nicks and scratches on my hands after a week from sticking my hands in little cavities, and I've only done it for three days... And each cut was made by a rusty surface covered in grease and sea water.

US Safety Depot - Abratex All-Grip Dominator DynaGrip Terminator TriMax Duralon Dyneema MaxPly Sanifresh Nitrile

I've used the "Terminator" series before but am looking for something approximately as thin but that provides all-around-the-hand protection.

 

begle, u just need to man up, its only scratches

they look to be good. at ranger they had thinner gloves than that for employees to use

 

What are gloves? I hear all you can do with gloves on is **** your pants. Jk begle at the refinery they require kevlar gloves when you use anything sharp and they weren't too bad....for gloves.

 

I imagine that if I had gloves I would end up not using them most of the time because the clearances are that small in a lot of these cavities, but it's a nice thought at least...